+91 8073744810 / [email protected]


Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino



  • Adopts high sensitivity ball switch SW-520D angle sensor
  • Comparator output, high driveability, over 15ma current
  • Working voltage:3.3V-12V
  • With screw mounting hole
  • Adopts LM393 comparator
  • The output format: digital switching outputs (0 and 1)
  • A fixed bolt holes for easy installation
  • Small PCB board size: 3.2cm x 1.4cm
  • Using a wide voltage LM393 comparator
Add to Wishlist
Add to Wishlist

The Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino comes equipped with the basic components for operation. Supply power to it, and it’s ready to go. Additionally, attach it to an object, and it will detect whether the object is tilted. Its usage is simple because it provides digital output; therefore, you can determine the object’s tilt status by reading the output. However, it’s important to note that it utilizes the SW-460D or SW-520D tilt sensor, so it specifically the ball rolling type rather than the Mercury type.

In addition, it features an M3 mounting hole on board, making it easy to attach to an object. Furthermore, the module offers a tilt switch with high sensitivity, making it a common choice for tilt detection. Moreover, the module includes power and status LEDs for visual feedback.

Nonetheless, there are certain limitations to be aware of. The module will output a logic LOW signal when it is not tilted beyond the threshold angle. Conversely, it will output a logic HIGH signal when it is tilted beyond this threshold angle.

Additionally, it’s worth noting that the threshold angle is relatively large, ranging from 45 degrees to 130 degrees, with the actual value dependent on the angular velocity. Moreover, this module can also function as a vibration sensor and can be interfaced with any microcontroller featuring digital input compatibility, such as the 8051, PIC, SK40C, SK28A, and SKds40A.

Pin Connection:
  1. VCC = 5V
  2. GND = 0V.
  3. DO = digital output from module
Note: If the DO is not working, you might need to turn the on-board potentiometer to center.


Features :

  1. Ball Rolling type of tilt sensor.
  2. Because this small module is easy to use.
  3. A fixed bolt hole for easy installation
  4. Wide voltage LM393 comparator


Package Includes :

1 x Tilt Sensor Vibration Alarm Vibration Switch Module.

Specifications :-

Operating Voltage (VDC) 3.3 ~ 5
Length (mm) 30
Width (mm) 14
Height (mm) 6
Weight (gm) 3

To Learn More Visit our Website

For more information:-www.mifraelectronics.com 
* Product Images are shown for illustrative purposes only and may differ from actual product.

Packages includes:-

  • 1 x Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino


There are no reviews yet.

Be the first to review “Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino”

Your email address will not be published. Required fields are marked *