470 k ohm-1/4 watt Resistance
A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors act to reduce current flow, and, at the same time, act to lower voltage levels within circuits. In electronic circuits, resistors are used to limit current flow, to adjust signal levels, bias active elements, and terminate transmission lines among other uses.
Also Searched as : 1/4 Watt Resistor, 470 k ohm resistor, 470 k ohm resistor buy online, 470 k ohm 1/4 watt resistance online india, resistance 470 k ohm buy online india,
Definitions and Calculations
Resistor and Resistance
A resistor is a passive electrical component that creates electrical resistance in electronic circuits. Resistors can be found in almost all electrical circuits. They are used for various purposes, for example, to limit electric current, as voltage dividers, to provide bias to active circuit elements, to terminate transmission lines, in resistor-capacitor circuits as a timing component… The list is endless
The electrical resistance of a resistor or an electrical conductor is a measure of the opposition to the flow of electric current. The SI unit for resistance is the ohm. Any material shows some resistance except superconductors, which have zero resistance. More information about resistance, resistivity and conductance.
Of course, it is possible to make a resistor with very precise resistance, however, it will be insanely expensive. Besides, high precision resistors are relatively rarely used. There are very expensive resistors used for measurements. Here we will talk about inexpensive resistors used in electric circuits, which do not require high precision. In many cases, ±20% of precision is enough. For a 1 kilohm resistor, this means that any resistor with a value in the range of 800 ohms to 1200 ohms is acceptable. For some critical components, the tolerance can be specified as ±1% or even ±0.05%. At the same time, it is hard to find 20% resistors today — they were common at the beginning of the transistor radio era. 5% and 1% resistors are very common today. They were relatively expensive in the past, but not anymore.
When an electric current passes through a resistor, it is heated and the electrical energy is converted into the thermal energy, which it dissipates. This energy must be dissipated by the resistor without excessive raising its temperature. And not only its temperature but also the temperature of components surrounding this resistor. The power consumed by a resistor is calculated as.